Installing Towel Bars is not a difficult task. The following paragraph will tell you how to install towel bars.
A towel bar is one of the essentials in a bathroom. Besides holding a towel, a good towel bar can also be used to embellish your bathroom. If you think that you have the best bath towel, then you would surely want the best towel bars, won’t you? A variety of Towel Bars are available in the market, so you might have a tough time choosing the right one. You should choose one that will complement your bathroom.
To enhance the utility of a towel bar, it is important to install Towel Bars at an apt position.
If your bathroom has studs, see that at least one of the mounting plates should be positioned on a stud, this will assist the towel bar in tolerating the weight of the wet towels. After you are done finalizing the position, measure the length of the towel bar and using this measurement mark the location of the mounting plates on the wall. Use a masking tape to mark the position.
The next steps to install towel bars is masking tapes indicate the positions of the mounting plate; take a pencil and mark the drilling spots on those positions. Make sure that the drilling spots are leveled before you proceed. Now, drill holes on the wall. Place the mounting plate on the right location, and fasten it using a screw. If the hole is not on a stud, then you will have to use a toggle bolt. If your wall has ceramic tiles, then you should also use screw anchors.
Some towel bars come with all the screws and the screw anchors that you will need to install towel bars, but they might lack quality. So, I advise you to inspect them properly before you use them. If you are not satisfied with the quality, get the screws and the screw anchors from a home improvement store. You should be careful while drilling, wear protective eye gear. When you are drilling ceramic tiles, see that you do not damage the tiles, it is better that you drill on the grout line.
It is very important to check whether the towel bar is installed properly. So, yank the towel bar after you are done to install towel bars. If you feel that it is not tight, find out where the problem lies, and fixes it. If you follow the steps to install towel bars mentioned above accurately, then you will not have any problems.